Honda Cm 125 Service Manual

  

2000 Honda CM 125 C service manual. Service Manual Honda CM125C @ Posted by danielk5 on Oct 27, 2010. Clicking this will make more experts see the. Clymer repair manual is written specifically for the do-it-yourself enthusiast. From basic maintenance to troubleshooting to complete overhaul of your vehicle, Clymer manuals provide the information you need. Designed to help you take care of your vehicle Will help you be one step ahead. $33.99 - $57.56.

Engine Shop Manuals and Service Support Materials

Like to do-it-yourself? Honda Engines offers a variety of Honda Genuine service materials for purchase. Items include:

Honda cm 125 service manual pdf
  • Service/repair manuals
  • Parts Catalogs
  • Generator Troubleshooting Manual
  • Carburetor Troubleshooting Manual
  • Binders
  • And much more!

These items are available to purchase from:

Please note: materials are for engines sold in the USA, Puerto Rico and the US Virgin Islands only. Non-U.S. customers can find a local distributor here.

To order, you will need to know the model name and serial number of your engine. Find your model and serial number here.

Honda 125 for sale

Related Honda TRX125 Searches:

VALVE CLEARANCE

Inspect and adjust valve clearance while the engine is cold and the piston positioned at Top Dead Center (TDC) on compression stroke.

1. Remove the seat.
2. Remove body panels and fuel tank as necessary to gain access to valve cover.
3. Remove the spark plug high tension lead and remove the spark plug. CAUTION: Place a clean shop towel into the spark plug cavity to prevent dirt from entering.
4. Remove plastic valve plugs.
5. Remove timing inspection plug from recoil housing. CAUTION: Failure to position the crankshaft at TDC on compression stroke will result in improper valve adjustment.
6. Rotate engine slowly with recoil rope, watching the intake valve(s) open and close.

Honda Cm 125 Service Manual

Honda Cm 125 Service Manual Free

NOTE: Observe the intake valve closing and then start to open, continue to rotate until the “T” aligns with pointer. The camshaft lobes should be pointing downward.

7. Verify accurate TDC positioning by observing the “T” mark aligned with the pointer in the timing inspection hole. In this position there should be clearance on all valves.

INTAKE VALVE CLEARANCE ADJUSTMENT

1. Insert a .006″ (.15mm) feeler gauge between end of intake valve stem and clearance adjuster screw.
2. Using Valve/Clutch Adjuster (PA--44689), loosen adjuster lock nut and turn adjusting knob until there is a slight drag on the feeler gauge.
3. Hold adjuster screw and tighten adjuster lock nut securely.
4. Re-check the valve clearance.
5. Repeat adjustment procedure if necessary until clearance is correct with locknut secured.

EXHAUST VALVE CLEARANCE ADJUSTMENT

Service

NOTE: The exhaust valve is adjusted thesame as the intake valve.

1. Insert .006″ feeler gauge between end of exhaust valve stem and adjuster screw.
2. Loosen locknut and turn adjuster screw until there is a slight drag on feeler gauge.
3. When clearance is correct, hold adjuster screw and tighten locknut securely
4. Re-check the valve clearance.
5. Repeat adjustment procedure if necessary until clearance is correct with locknut secured.
6. Inspect o-rings on the plastic valve plugs, replace if damaged. Securely fasten valve plugs.
7. Reinstall fuel tank and any body panels that were removed to gain access.

Honda Cm 125 For Sale

EXHAUST VALVE CLEARANCE:

Honda Cm 125 Service Manual Pdf

0.006±0.0008I (0.15±0.02 mm) BTDC on compression